Jealous Again — The Black Crowes1 / 2
Original RigYour Adaptation
GuitarDistortedRiff80% confidence

Jealous Again Riff Guitar Tone Settings — The Black Crowes

The Black Crowes · 1990s · rock

studio

Original Recording

Guitar
Fender Blonde Telecaster (Rich Robinson's main guitar on 'Jealous Again')
Pickups
Single-coil (Fender Telecaster stock bridge and neck pickups; neck pickup possibly replaced with oversized humbucker, but Blonde Tele likely stock single-coil for this song)
Amp
Marshall Silver Jubilee half-stack
Pickup Position
Bridge pickup

Studio recording, 1990. Rich Robinson used his Blonde Telecaster and a Marshall Silver Jubilee half-stack for the main riff on 'Jealous Again'. No evidence of live rig or alternate guitars for the studio riff section. Open G tuning, down a half step.

Amp Settings

Mids
7
Bass
6
Gain
5.5
Reverb
2.5
Treble
6.5
Presence
6

Tone Matcher

Match This Tone to Your Gear

Tell us your guitar and amp — we’ll calculate the exact settings translated to your specific rig.

Adapt to MY Gear →

7-day free trial · Cancel anytime.

Tone Character

  • raw and driving
  • warm and overdriven
  • dirty and aggressive
  • vintage British crunch
  • dynamic and punchy
  • ringing open chords
  • percussive attack
  • slightly compressed
  • edge-of-breakup
  • bright and articulate

Notes & Caveats

  • ⚠️No direct numeric amp settings found; settings estimated based on typical Marshall Silver Jubilee usage for classic rock rhythm tones and era.
  • ⚠️No explicit pedal or effect model confirmed for the studio riff section; overdrive/fuzz pedals are associated with the band but not specifically cited for this song's studio riff.
  • ⚠️Pickup choice inferred from typical Telecaster usage for rhythm and the song's bright, cutting tone.
  • ⚠️No evidence of time-based or modulation effects (delay, chorus, flanger, etc.) in the riff section; only amp reverb is likely present at a low level.
  • ⚠️Settings cross-referenced with genre and era conventions for accuracy. Rich Robinson's 'Jealous Again' tone is classic early '90s blues-rock: edge-of-breakup to mild crunch, with pronounced mids and a warm, punchy low end. Likely using a vintage Marshall or Fender amp, the settings favor mid-forward British rock tones with just enough reverb for space, matching the song's open, rootsy vibe.

Sources